This tutorial shows how you can make a beautiful ribbon roses. You can use it in different ways – for decoration gifts, or on a headband or impale it on the wire and put in a vase. Do not be discouraged first setbacks, it was initially too braided fingers and roses was falling apart, but with a little patience you’ll do in a minute gorgeous roses.
Check it out complete tutorial.
Required Material:
- Ribbons
- Thread
- Scissor
Size of roses depends on the width of ribbons used:
- When the ribbon width of 2.5 cm a cutoff of about 33 cm long ribbon (orange roses).
- Purple roses: Ribbon 4 cm width of a cutoff of about 66 cm long ribbon.
- Red roses: Ribbon width of 5 cm a cutoff of approximately 1 meter long ribbon.
Step by step procedure:
Ribbon on the edge translate into as shown in image.
From the left side of the folded portion begin ribbon scroll inside.
Rolujeme until we come to the end of the bent part of the ribbon.
We turn to bow out to form our first petal roses.
And again we rolujeme.
Ribbon again we turn to the outside are, scroll. Repeat several times.
In the middle of us while sticking petals as follows.
Pull the end of the ribbons, which immerses the first petals inside.
Rose thereby becomes more beautiful shape.
A further bend down to bow out are, scroll.
We can shape rose slightly pulling the petals.
Repeat the process until we figure the end of the ribbon.
The ends of the ribbons to catch.
A few times they wrapped thread and firmly committing to.
The final shape can we adjust by pulling some buck.
A Rose is done.
Surely write us how you managed the production of ribbon rosette. If you happen to struggling, write well. And if you have done roses, you can send us a photo and add it to the end of this article.
Hope you like this tutorial. Thanks for visiting our website. Keep creating with K4 Craft!
