DIY: Bracelets for bridesmaids (Tutorial)

Bracelets for bridesmaids:

How quickly make a nice gift for bridesmaids, which not only pleases, but will remain as a garnish.

Required Material:

  • Colored satin
  • Tough paper
  • Compass
  • Scissors, needle, thread
  • Ribbon – 2 cm or 2.5 cm wide – length 50 cm
  • Hot glue gun
  • Candle
  • Decorative buttons

The paper traces out a hard or a compass draw two different circular template (these had a diameter of 7.5 cm and 7 cm, but make them more beautiful flowers layered may be of three and even more apart, on average – for example, 1 cm or 1.5 cm).

The templates can cut out 6 circles need not be uniform, but whatever it is visible that it should be circles 😀 (3 higher and 3 lower)

Circles cut from all sides. The last to be on top, should have the deepest cuts.

The edges floret opals over a candle, we pretty twisted and the threads are sealed, so they do not steam.

Kvietky stack on top of each other and begin to sew the ribbon whose ends we welded up over a candle or a lighter. This should be at least 2 cm wide and about 50 long for us to tie a bow on. For smaller detičky may be less.

Finally Glue the decorative buttons or decorative brooches.

A result that will please especially small bridesmaids 🙂 A beautiful example is suitable for luxury satin bouquet.

Hope you like this tutorial.

Keep creating with K4Craft!