I bring to your attention a small decorative element of the interior, a small stylized autumn tree.
Required Material:
– Wire for the frame (for example, steel)
– wire for weaving (aluminum) 1mm
– Foamiran of two colors (yellow, orange)
– plastic “Hearty”
– acrylic paints
– silicone mold “rose leaf”
– beads
– glue gun, pliers, iron,
1. We make the basis of our tree. Steel wire bends in the form of a tennis racket and wrapped with aluminum wire, as shown in the photo:
For the stand, I took a wooden cup, you can use any unnecessary dishes, for example, a teapot, it will turn out very snug ? We fix our tree with alabaster, let’s dry:
While our tree is drying, let’s go directly to the “crown”. I decided to make it in the form of a stylized golden dog rose.
2. Berries. We make teardrop-shaped beads, on the one hand, we make a deepening. Let’s dry and then paint with acrylic paint.
For the tails we cut out the furnish “fence”, wind it on a small piece of wire and the tip is sealed with a hot pistol, drag the wire from the “tail” through the bead and paste it in the groove.
Turn on the iron, put it on devotchka. When the iron is warmed up, we press the “tail” of the bead for 2-3 seconds and then twist the fingers with the warmed-up foamiran, “ponytail” with gold paint.
Turn on the iron, put it on devotchka. When the iron is warmed up, we press the “tail” of the bead for 2-3 seconds and then twist the fingers with the warmed-up foamiran, “ponytail” with gold paint.
3. Berries for the time being put aside, we will deal with flowers. For this, we cut out two sizes of petals, and we mold the middle in the form of a donut. Petals heated on the iron, reducing it to one. The petal after heating is pressed with a finger at the base of a piece of foam rubber.
For the stamens, we cut out the streaks of the former and finely chop one edge. Tinted with golden paint and on the iron, then paste on a bagel, first bend to a bagel, the second layer in the opposite direction.
Now we paste the petals
Tinted:
4. For the leaves, we make a pattern of three sizes and cut out about 15 pieces from the foamran, we can do a little more, as the saying goes, “do not spoil the porridge with oil,” there will not be a lot of leaves. We heat on an iron and apply it on a mold, to form veins. If there is no mold, streaks can be pressed with a toothpick. Paint the leaves.
Some of the leaves are collected in a twig with the help of a glue gun, the berries are twisted into a bouquet of several pieces.
Twisted twigs are screwed into the base in a fantasy order.
Using his imagination, we have flowers, leaves, and berries, beads in an improvised bouquet, not forgetting to mask the leaves with the wrong side.